EFILive Release Notes
Version Numbers
EFILive Software V8.3.23
· FlashScan/AutoCal V3: Firmware: V3.00.091 (Boot Block: V3.00.006)
· FlashScan/AutoCal V2: Firmware: V2.08.190 (Boot Block: V2.08.009)
EFILive V8 Software
V8.3.23
· Added two new serial-based, wide-band, BEN factor PIDs: BENLAM_1 and BENLAM_2, based on commanded v's actual lambda.
· Added visual/color alarms for dashboard gauges.
· Added right-click option to manually reset min/max, tell-tale values on dashboard gauges (or hotkey Ctrl+R).
· Fixed selection bug when moving gauges up/down in the gauge list of the dashboard editor.
· Fixed "Item not found" error when deleting a gauge while it was expanded, with its details visible.
· Fixed bug that allowed non-calculated PIDs to be added to an existing data log. Only calculated PIDs may be added to an existing data log.
· Fixed "integer overflow" error when loading user defined PIDs that have one or more DMA operating systems defined but zero DMA PIDs defined.
FlashScan/AutoCal V3 Firmware
V3.00.091
·
When flashing a tune file via an AutoCal
device, verify that the AutoCal is linked to a FlashScan device before checking
if the tune file is linked to the AutoCal. That way an un-linked AutoCal will
report that it is unlinked instead of the more confusing error of "the
tune file is not linked to the AutoCal".
FlashScan/AutoCal V2 Firmware
V2.08.190
· Same change as V3.
Calibration Updates
V8.3.23
· CM2220
·
CM2350A
Documentation Updates
V8.3.23
·
Connections and Wiring Reference.pdf.
Known Issues
·
Issue #1: When
logging DMA PIDs (i.e., PIDs whose names end with "_M" or
"_DMA"), if the ignition is switched off for an extended period while
data logging but data logging is not terminated, then when the ignition is
switched on again the data log automatically continues. However, the DMA PIDs
may no longer return valid data.
Workaround: EFILive recommends
stopping the data log and restarting the data log when switching off the
ignition for extended periods.