EFILive Release Notes
Version Numbers
· EFILive V8.3.17
·
FlashScan/AutoCal
V3: Firmware: V3.00.086 (Feb 02, 2022)
Boot Block: V3.00.005 (Oct 20, 2020)
·
FlashScan/AutoCal
V2: Firmware: V2.08.185 (Feb 02, 2022),
Boot Block: V2.08.009 (Feb 27, 2021)
EFILive V8
V8.3.17
· Fixed fault that caused encrypted *.cax8 files to fail to load.
· Added option to convert single V7 cax definitions to V8 cax8 definitions.
· Added more descriptive error messages (based on the new, unique return codes from the firmware) when license conversion-codes fail in [F7: Licenses]->[F4: Conversions].
Calibration Updates
· CM2450A.
FlashScan/AutoCal V3
V3.00.086
· Added unique return codes when license conversion-codes fail.
FlashScan/AutoCal V2
V2.08.185
· Added unique return codes when license conversion-codes fail.
Documentation Updates
· None.
Known Issues
·
Issue #1: Importing
JTAG E86B files may result in a Boot Software segment checksum error.
Workaround: None. Don't flash
imported files with checksum errors. Don't use the EFILive software to correct
checksum errors for the E86B imported files as that does not fix the underlying
cause of the checksum error - it just masks the error(s) and causes additional problems.
·
Issue #2: When
logging DMA PIDs (i.e., PIDs whose names end with "_M" or
"_DMA"), if the ignition is switched off for an extended period while
data logging but data logging is not terminated, then when the ignition is
switched on again the data log automatically continues. However, the DMA PIDs
may no longer return valid data.
Workaround: EFILive recommends
stopping the data log and restarting the data log when switching off the
ignition for extended periods.